Discipad Numpad Kit

This batch will include stainless t6 torx screws instead of slotted brass scews.

• USB-C connector
• Only through-hole parts
• ATMEGA328P a controller
• Gold plated pcb and brass slotted screws
• QMK Firmware
• Build Guide (The way you assemble the case is very similar to the Plaid-Pad, Build Video)
• Bootloader (USBaspLoader) and Firmware (QMK) already flashed on the MCU

Since 18.08.2020 the VIA keymap is flashed on the MCU.
Download the VIA software for WIN/OSX from the VIA website and to easily change the keymap.
VIA Demo Video

The USB-C connector is a bit difficult to solder. I can do it for you.
 "Soldering service for USB-C connector"

Includes:

• Mid and bottom pcb (black/gold)
• Top plate (black FR4)
• 3mm clear acrylic guard plate (has bluish protection film)
• Solder parts with pre flashed Atmega328P
• Spacer and screws (stainless torx t6 screws)
• Rubber feeds

You also need:

• 17x switches (5pins for the alignment)
• 3x 2u stabilizers (optional)
• Dampening foam (optional)
• USB-C cable
• Keycaps
• T6 Torx screwdriver
• Soldering iron

Photos of the completed kit are for demonstration purposes only.
Please note that this kit must be assembled (soldering) and does not include switches or keycaps.

Design by Coseyfannitutti